Detroit DiagnosticLink Professional
The professional edition provides parameter settings, diagnostic fault codes, instrumentation, and service routines for non-chassis powertrain controllers (e.g., CPC, MCM, ACM, and D12 TCMs), the ability to reprogram ECU powertrain controllers. Programming events cannot be used to edit chassis parameters such as SRRR01T (Side Radar) /RDF02T (Radar Frontend 2) or reprogram chassis ECUs such as SSAM, CGW, or IPPC.
ECUs are supported for the following products:
- EPA07 – DD13, DD15, Series 60, MBE 900, MBE 4000
- EPA10 – DD13, DD15, DD16, GHG17, GHG21, Gen 5
- GHG14 – DD13, DD15, DD16, DT12 Transmission
- GHG17– DD5, DD8, DD13, DD15, DD16, DT12 Transmission
- GHG21/Gen 5 – DD13, DD15
- EURO IV – DD13, DD16
- EURO V – DD13, DD16
*To program an ECU, you must first purchase a programming event. Programming events can be purchased from Diesel Diagnostic Equipment for $280/each.
PSL/TechLit is for dealers only. PSL/TechLit is not included.
Detroit Programming Events
This allows programming of software and calibrations of Engine ECUs.
A programming event is required for each time an engine software/calibration is downloaded and programmed.
Engine ECU Reprogramming is supported for the following products:
- EPA07 – DD13, DD15, S60, MBE900, MBE4000
- EPA10 – DD13, DD15, DD16
- GHG14 – DD13, DD15, DD16, DT12 Transmission
- EURO IV – DD13, DD16
- GHG17 – DD5, DD8, DD13, DD16, DT12 Transmission
- EURO V – DD13, DD16
- GHG21/GEN 5 – DD13, DD15
NOTE: Programming events CANNOT be used to program chassis controllers and must be sent to a certified Daimler dealer.
